Call (561) 448-8545 24/7 Emergency Response · Boca Raton & Palm Beach County 2703 2nd St, Suite 14, Boca Raton, FL
Plumber installing a new toilet

Emergency Toilet Repair in Boca Raton, FL

A toilet that runs constantly, rocks when you sit down, or won't stop clogging usually traces back to one of a handful of worn parts, and most of these are same-visit fixes rather than a sign you need a full replacement.

Common Causes

What's usually behind each symptom

Running constantly

Almost always a worn flapper or fill valve that's letting water leak into the bowl between flushes, wasting water and raising the bill.

Rocking or unstable

Usually a worn wax ring or loose closet bolts at the base, which if ignored can let water leak onto the subfloor.

Repeated clogging

Often a partial blockage further down the drain line, or in older toilets, a design that simply doesn't clear waste efficiently.

A modern replacement toilet often uses less water per flush than one installed decades ago. Ask your building department if anything special applies to a replacement, since Florida plumbing rules are based on the International Plumbing Code (IPC).

A toilet installed before 1994 can use 3.5 to 5 gallons per flush, compared to the 1.28 to 1.6 gallons a modern low-flow model uses. That adds up to a real difference on a household's water bill over a year, especially in a multi-bathroom Boca Raton home.

24/7 Emergency

Emergency toilet repair: overflow, leak or no flush

An overflowing toilet, a toilet that will not flush, water leaking from the base or a supply line that has let go cannot wait. The water is clean or not, depending on the cause, and either way it spreads quickly across a bathroom floor.

If a toilet backs up and other fixtures also drain slowly, the problem may be the main line rather than the toilet. Our 24/7 line can send a technician who will check both.

While our emergency plumber is on the way

Stop the water and keep the floor dry.

  • • Close the supply valve behind the toilet by turning it clockwise.
  • • Lift the tank lid and raise the float if the bowl is still filling.
  • • Do not flush again, and mop up water so it does not reach other rooms.
  • • Note whether other drains are slow, since that points to the main line.
Repair vs. Replace

When a repair is enough, and when it isn't

SituationUsual fix
Running or slow to stop fillingFlapper or fill valve replacement
Rocking base, water at the floorNew wax ring, possibly a subfloor check
Cracked tank or bowlFull toilet replacement, not repairable
Old, high-water-use modelReplacement often pays for itself in water savings
Before You Call

What to check first

  • • If it's running, check whether the water level in the tank is above or below the overflow tube.
  • • If it rocks, avoid sitting on it forcefully until it's inspected, to limit any further wax ring damage.
  • • Note the toilet's approximate age if you know it. Older units use significantly more water per flush.

If more than one toilet in the house shows the same symptom at the same time, that's more likely to point toward a shared cause, such as sewer line or venting issue, than a coincidence of multiple fixtures failing separately.

Pricing

What changes the cost

Repair vs. replacementA flapper or fill valve swap costs far less than a full toilet replacement.
Subfloor conditionA rocking toilet that's been leaking for a while may have subfloor damage that adds to the job.
Toilet typeComfort-height, dual-flush, and wall-mounted models vary in installation complexity and cost.

Want your real number? Call (561) 448-8545 and describe the symptom.

Installation

What a proper install actually involves

A toilet installation is more than setting a new bowl on the same footprint. We check the flange height and condition, since a flange that's cracked or sitting too low under new flooring is a common cause of leaks and instability even with a brand-new toilet. A new wax ring or waxless seal is standard on every install, along with checking that the closet bolts are the correct length and properly seated, not just tightened down on whatever was there before.

Flooring changes are a common trigger for this issue: adding tile over an existing floor raises the finished height, which can leave the flange sitting too low relative to the new surface unless it's extended or shimmed correctly during installation. We check for this specifically on any install following a recent flooring project.

If you're remodeling a bathroom and haven't picked a toilet yet, we can talk through bowl shape, height, and flush type options during the estimate rather than you having to research and choose before we even arrive.

FAQ

Common questions

Not urgent, but worth fixing soon. A running toilet can waste a significant amount of water over weeks even if it isn't overflowing.

Not dangerous, but continuing to use it can worsen a wax ring leak and lead to subfloor damage, so it's worth scheduling a repair promptly.

It depends on your water bill and how old it is. Pre-1994 toilets can use more than double the water of a modern low-flow model.

Yes, including comfort-height, dual-flush, and wall-mounted models, though wall-mounted units need in-wall tank access considered before installation.

Ready to get it fixed? Call (561) 448-8545.

Related

If it's more than the toilet

A toilet that clogs repeatedly alongside other slow drains may point to the sewer line rather than the fixture itself, and general drain cleaning covers most single-fixture clogs. Not sure which applies? Call (561) 448-8545 and describe what you're seeing.

Local Knowledge

Toilets in condo buildings and single-family homes

In condo buildings around Mizner Park and the beach, a running or leaking toilet wastes water and can damage the unit below. In single-family neighborhoods, worn flappers, fill valves, and wax rings are the usual causes. Either way, the first step is working out whether the fix is a part or a replacement.

Coverage Area

Where we work

Call (561) 448-8545 · 24/7 Emergency